Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Raynor Cable & Drum Replacement: The Marble Falls Owner’s Guide
Raynor cable and drum replacement in Marble Falls typically runs $130-$250 installed, and we stock the common Raynor sizes on our trucks for same-day completion. Most homeowners notice the problem when the door hangs crooked, slams shut, or won’t lift at all after a loud snap from the side of the track. The cable and drum work as a matched pair under constant tension, and when one fails, the other is usually not far behind.
Which Raynor Models This Applies To
Raynor has used several drum profiles across their product lines, and matching the wrong one will throw off your door’s cable wrap geometry. The most common we see in Marble Falls are the 4-inch standard-lift drums on Raynor Advantage and Builder series doors from the 1990s through mid-2000s, and the 5-inch high-lift drums used on newer Raynor Distinction and Aspen models with taller ceiling clearances. The part number is stamped on the drum hub itself, usually visible once you release tension and rotate the drum, but the cable diameter matters just as much: 1/8-inch and 5/32-inch are the two standards, and swapping them will chew up a drum groove in short order.
Raynor OEM cables come with factory-crimped loops and precisely measured lengths. We also carry quality aftermarket cables from Precision and IDC that match Raynor specs for homeowners who want the repair done without the OEM markup. Mainspring Garage Door Co. is an independent service provider, not affiliated with Raynor, so we source what fits best for your specific door age and usage. If your Raynor label is worn off, we measure drum diameter, cable length, and shaft size on-site rather than guess.
Signs Your Raynor Cable & Drum Replacement Is Failing
- The door hangs crooked or one side drops faster. When a cable frays or a drum slips on the torsion shaft, the lift becomes uneven. The door tilts toward the weak side, and the opener strains or reverses because the safety sensors detect the misalignment.
- A loud snap or pop from the side of the door, then silence. That sound is usually a cable breaking under load. Raynor cables in the Hill Country see extra wear from temperature swings, dry air, and occasional humidity off Lake LBJ that accelerates surface corrosion where the cable wraps on the drum.
- The cable is unwound from the drum and dangling loose. This happens when a drum set screw loosens or the keyway wallows out. The cable loses tension entirely, and the door becomes dead weight on one side.
- Visible fraying, rust blooming, or broken strands near the loop end. Cable failure starts at stress points. On Raynor doors, the bottom loop and the first wrap around the drum are where we find the most deterioration during tune-ups in Marble Falls.
- The drum rotates but the cable does not move, or moves erratically. A cracked drum hub or stripped set screw bore will spin freely on the shaft. The opener runs, the drum turns, and nothing happens at the door.
Replacement Cost & What’s Included
| Service | Price Range in Marble Falls |
|---|---|
| Cable & Drum Replacement (single side) | $130-$250 |
| Cable & Drum Replacement (both sides) | $220-$400 |
| Additional torsion spring adjustment if needed | No extra charge |
The $130-$250 range covers removal of the failed cable and drum, installation of matched replacements, re-tensioning the torsion system for level lift, and a full cycle test before we leave. Both-sides replacement costs more because the job takes longer and uses double the parts, but we discount the labor on the second side since the tools are already out. We state the flat price before touching a wrench, and that number does not change at the invoice. Every cable and drum replacement carries our 90-Day Done Right Promise in writing: if it is not right, we come back at no charge.
DIY or Call Us?
There is a safe middle ground here, and then there is a hard stop. A homeowner can visually inspect cables for fraying, check that drums are seated on the shaft, and look for loose set screws without risk. What you should not do is loosen or remove a cable while the torsion spring is still wound. The spring stores enough torque to spin a drum fast enough to break a hand or launch a winding bar across the garage. We have responded to calls in Marble Falls where someone watched a video, started the job Saturday morning, and spent the afternoon in the emergency room.
If your Raynor door is stuck open, stuck closed, or the cable is fully detached, the spring is under load whether the door is up or down. That is the point to stop looking and call (737) 520-8686. We carry Raynor-compatible drums and cables on every truck, and most replacements are finished in under an hour.
FAQs
Most last 8 to 12 years with normal residential use, though the Hill Country’s temperature swings and occasional lake humidity can shorten that to 6 or 7 years on doors facing direct afternoon sun. Annual lubrication of the cable-drum interface adds two to three years. Call (737) 520-8686 for an exact quote - estimates are free.
No. A frayed cable has already lost structural integrity, and splicing or clamping creates a weak point that will fail under load, often without warning. We replace the cable and inspect the matching drum for groove wear every time. Call (737) 520-8686 for an exact quote - estimates are free.
Most single-side replacements take 45 minutes to an hour, including safety checks and cycle testing. Both sides run 75 to 90 minutes. We carry the parts, so there is no waiting for a second trip. Call (737) 520-8686 for an exact quote - estimates are free.
Yes. We stock 1/8-inch and 5/32-inch cables in standard lengths, plus 4-inch and 5-inch lift drums that fit Raynor’s most common residential lines. For older or specialty Raynor models, we can source same-day from our Marble Falls warehouse if the truck stock does not match. Call (737) 520-8686 for an exact quote - estimates are free.
Carl Dutton learned this trade at Los Angeles Trade-Technical College before garage doors became his focus, and he has spent well over a decade running service calls across the Hill Country, including jobs out near the Lake LBJ waterfront corridor where a stuck door on a boat-storage garage will ruin a perfectly good Saturday morning. Quote it flat. Do it right. Move on.
If your Raynor door is hanging crooked, snapped a cable, or the drum is spinning loose, call us at (737) 520-8686. A live person answers day or night, we will state the price before we start, and most jobs are done in a single visit. We also honor a permanent 5% discount for seniors and veterans, and we offer $50 off any repair over $250.
Written by Carl Dutton, Owner, Mainspring Garage Door Co. at Mainspring Garage Door Co., serving Marble Falls and nearby areas.






Before
After
Before
After
Before
After